Roof Repair in Denver, CO
Damaged shingles. They happen to all of us. Though some homeowners may think of them with dread, other hardy souls recognize them as a minor inconveniences that can be repaired with a hard day’s work. If you don’t have the time, ability, or simple inclination to spend a day up on the roof, though, don’t worry. It’s just as easy to pick up the phone and call a reputable roofing company to do it for you! For the handymen and adventurous spirits, read on to find out how to repair damaged shingles on your roof.
Inspect Roof for Damaged Areas
The first thing you’re going to need to do is to thoroughly inspect your entire roof for any signs of damage. Keep in mind that damage is not always as immediately obvious as cracked, missing, or loose shingles. It could also be shingles that have been dislodged just slightly, but still enough to allow water to collect and seep through into your home. Keep a vigilant eye out for areas like these, or else you’ll be back up on the roof next weekend. Mark areas in need of repair on a notepad, either in list form or on a sketched out map of your roof layout- whatever works for you.
Source Matching Materials
Before you get up on the roof and start ripping things out, you’re going to want to ensure that you can find new shingles that match or compliment your existing ones at a reasonable price. If you neglect to do this first, you may have to make some unfavorable compromises later on down the line and end up with a roof that looks more like a patchwork quilt. Take a look around and order your materials early.
Remove Damaged Shingles
After you’ve identified all the areas of your roof that need some TLC, you will need to remove the shingles that are damaged beyond repair. To do this, gently tap a pry bar underneath the shingle and lift up, being careful not to apply too much force and tear the shingles. It’s much easier to remove one whole shingle than several pieces of what used to be one shingle, so take your time with it. Also be sure to remove or nail down any and all nails that were holding the shingles in place, or these will cause problems for you later. Make sure not to remove any more shingles than you can replace within that same day (use a conservative estimate in case you run into complications) and keep an eye on developing weather conditions as you work.
Slide new shingles into the places where the old shingles used to be, making sure to prop up the rows of shingles above as you do this. Start by nailing the center row in place first, followed by the center row of the upper course, and then at the top of the slots between tabs. Place all your nails about ½ inch to either side of the original holes to ensure security.